9.  CCpilot V1000/V1200/V510/V710 and Yukon development board
==============================================================

This chapter covers features and behavior unique to the CCpilot V1000/V1200/V510/V710 and the Yukon development board.

============================================================
9.1 Status indication (LED and buzzer)
============================================================

This section describes the basic default status indication behavior. Note that the status indication behavior can be disabled totally and/or configured by user software through the CCAux API.

------------------------------------
9.1.1 Startup sequence
------------------------------------

During startup to the main system, the status LED and buzzer indications are as follows:

    • Flashing yellow at 1 Hz: pre-heating is activated and in effect, start-up is delayed while the device is heated.

    • Status LED is blinking yellow at 2 Hz and buzzer makes short beep: Device start-up phase begins.

    • Operating system is then started, and specific service software begins to execute.

    • Status LED is constant green: Device is operational.

------------------------------------
9.1.2 Suspend
------------------------------------

When the device is in suspend mode, the status LED indications are as follows:

    • Flashing yellow at 0.2 Hz: system is suspended.

    • Flashing yellow at 2 Hz: system is resuming from suspend.

    • Static green: device is operational.

------------------------------------
9.1.3 Shutdown sequence
------------------------------------

Once ignition signal has been released and shutdown is initiated:

    • Status LED is constant yellow, and buzzer makes short beep: shutdown sequence has started.

Status LED is off: Device is off