# Installation guide

## Supported platforms and devices

* i.MX 8
  * CCpilot V700
  * CCpilot V1000
  * CCpilot V1200
* i.MX 6
  * CCpilot VI2
  * CCpilot VS
* i.MX 5
  * CCpilot VA
  * CCpilot VC
  * CCpilot XA/XS
* Core i7
  * CCpilot X900
* LinX Software Suite DevEnv v4

## Prerequisites

* On versions up to 3.2.0, Qt 5.4.0 or newer

## Installing Data Engine

### i.MX 8

1. Download `dataengine_<version>_imx8_USB.zip` from the support site.
2. Extract archive content to an USB flash drive.
3. Attach the USB flash drive to the unit.
4. Wait for the installer to finish.
   * One beep - Success
   * Two beeps - Failure
5. A file named `install.log` is stored on the USB flash drive and contains information regarding the installation.
   Refer to this log in the case that the installation fails.
6. Detach the USB flash drive form the unit.
7. Data Engine will start automatically during next system startup

### i.MX 6

1. Download `dataengine_<version>_imx6_USB.zip` from the support site.
2. Follow steps 2-7 from [i.MX 8](#i-mx-8).

### i.MX 5

1. Download `dataengine_<version>_imx5_USB.zip` from the support site.
2. Follow steps 2-7 from [i.MX 8](#i-mx-8).

### Core i7

1. Download `dataengine_<version>_corei7_USB.zip` from the support site.
2. Follow steps 2-7 from [i.MX 8](#i-mx-8).

### LinX Software Suite DevEnv v4

These steps are intended to be performed in the UX Designer VM.

1. Download `dataengine_<version>_amd64.deb` from the support site
2. Double-click on the package to open it with GDebi
3. Follow the instructions to install the package

It's also possible to install the package using the terminal:

``` shell
sudo apt install ./dataengine_<version>_amd64.deb
```

## Troubleshooting

Please refer to our [Knowledge Base](https://support.crosscontrol.com/knowledge-base) for
further information and troubleshooting guides.